Skip to main content
VenueNext Training

Hardware Setup

Open section menu

Plugging in the device

Hardware_Picture18.png

If you are looking at the screen of the POS device, the network cable will be plugged in on the left and the power cable will be plugged in on the right.

Hardware_Picture19.png

1. Thread the power and ethernet cables through the bottom of the mount and then through the mount until they can reach the ports

Hardware_Picture20.jpg
Hardware_Picture21.jpg

2. Plug in the cables:

Hardware_Picture22.png

When inserting the cables, make sure the tab on the end of the ethernet faces towards the ground, and the tab on the power cable faces away from the device (to the right if you are looking at the screen, left if viewing the device from the back)

Hardware_Picture23.jpg

To unplug the register, unplug both cables and remove them from the mount.

data-content-type=""

VenueNext Training Resources

overrideBackgroundColorOrImage= overrideTextColor= promoTextAlignment= overrideCardHideSection= overrideCardHideByline= overrideCardHideDescription= overridebuttonBgColor= overrideButtonText= promoTextAlignment=